Creating Multiple Networks on VMware Player

Home / Creating Multiple Networks on VMware Player

Creating Multiple Networks on VMware Player

December 9, 2015 | Article | No Comments

In VMware Player, there are three network options for guest VMs: bridged network, NAT network, and host-only network.

vmware-1

What if you want to create multiple isolated networks, running the VM and have the networks run available at once? Each of which is reachable via different network interfaces attached to the VM. Surely this is interesting, but if the network choices are limited to the one above three options, we can’t make our idea real.

Therefore, in this article we will discuss about how we can “hack” VMware Player so it can accommodate our idea.

The Theory Behind

The feature we use is “LAN segments”. Using this, we can define multiple LAN segments, each of which represents an isolated virtual LAN. We can then add our VM as many LAN segments (corresponding network adapters) as we want. Both VMware Workstation and VMware Player have this feature so you can apply it to VMware Workstation too. However, on Linux it seems that LAN Segments is not shown by default.

Each LAN segment act as a VPN (Virtual Private Network). This way, more than one isolated network can be formed.

Creating LAN Segment

In order to create and assign a LAN segment to VMware Player VM, first create a new VM instance with two network interface (one bridged and the other NAT interfaces) using Virtual Machine Wizard. Do not turn on the VM at this point. Instead, open up .vmx file of the VM and edit it as follows.

Search for the lines that reads “ethernet1.xxxxx”. This is configuration for network interface eth1

ethernet1.present = "TRUE"
ethernet1.connectionType = "nat"
ethernet1.virtualDev = "e1000"
ethernet1.wakeOnPcktRcv = "FALSE"
ethernet1.addressType = "generated"

Currently eth1 is set to use NAT. We will reconfigure it so that it uses a LAN segment instead. For that, change the above configuration as follows:

ethernet1.present = "TRUE"
ethernet1.connectionType = "pvn"
ethernet1.pvnID = "52 dd bc d5 36 19 1b 6b-0f f1 fb 1c 4c ac 44 f7"
ethernet1.virtualDev = "e1000"
ethernet1.wakeOnPcktRcv = "FALSE"
ethernet1.addressType = "generated"

As seen there, two changes made. First, ethernet1.connectionType was change to “pvn” (Private Virtual Network). Also, there is a new entry, ethernet1.pvnID which identifies the LAN segment that the VM will be attached to. You can fill in any arbitrary pvnID in the same alphanumeric format; it will be regenerated by VMware Player later on.

Once changes are saved to .vmx file, open the guest machine’s VM settings on VMware Player. Now you will notice that LAN segment configuration menu magically appears on VMware Player GUI, as shown below.

vmware-2

If it isn’t shown up yet, close VMware Player and start it up again.

From the drop down menu of LAN segments, you can choose “LAN Segment 1″ which was created by our manual editing of .vmx file. You can also create as many LAN segments as you want, by clicking on “LAN Segments” button, which will show you a LAN segment management interface.

All the VMs that are attached to the same LAN segment are physically on the same layer-2 network. VMs that are assigned to different LAN segments are physically separated.

Note that there is no pre-configured DHCP service running on the LAN segments you create. Therefore, if you want to have your VM assigned a DHCP IP address from a given LAN segment, you will need to run a DHCP server on one of your VMs on the same LAN segment. Alternatively, you could use a static IP address.

,

About Author

about author

xathrya

A man who is obsessed to low level technology.

Leave a Reply

Your email address will not be published. Required fields are marked *

Social media & sharing icons powered by UltimatelySocial